Specturm NYMPHEA 24W

Hi, I bought this one https://spectrumsmart.pl/pl/p/Oprawa-LED-Wi-FiBluetooth-NYMPHEA-24W-1840lm-CCT-DIM-230V-130st-IP20-390x70mm-BIALY-okragla/87 - it uses WB3L and it has 2.9.16 version.

and I was naive that one of the profiles there would work with OpenBeken. I run cloudcutter and basically from logs I think it flashed openBeken because script finished with:

[DEVICE OTA] Responding to device OTA HTTP request range: bytes=0-464975/464976
Sending firmware update message {"data":{"firmwareType":0},"protocol":15,"t":1671744597} using protocol 2.2
Firmware update messages triggered. Device will download and reset. Exiting in 30 seconds.
[I 221222 21:29:59 web:2271] 206 GET /files/OpenBK7231T_UG_1.15.221.bin (10.42.42.15) 57.88ms
[DEVICE OTA] Responding to device OTA HTTP request range: bytes=359968-464975/464976
[I 221222 21:30:04 web:2271] 206 GET /files/OpenBK7231T_UG_1.15.221.bin (10.42.42.15) 54.68ms
[DEVICE OTA] Responding to device OTA HTTP request range: bytes=359968-464975/464976
[I 221222 21:30:07 web:2271] 206 GET /files/OpenBK7231T_UG_1.15.221.bin (10.42.42.15) 55.57ms
[DEVICE OTA] Responding to device OTA HTTP request range: bytes=359968-464975/464976
[I 221222 21:30:13 web:2271] 206 GET /files/OpenBK7231T_UG_1.15.221.bin (10.42.42.15) 52.80ms
[DEVICE OTA] Responding to device OTA HTTP request range: bytes=359968-464975/464976

but the device is stuck on A-**** wifi Access Point. I did not dump the device (my bad) -> is there any way to rescue it?

[GalGavu]

Brought laptop as close as possible to the light - flashed perfectly with Openbeken. Thanks for helping me out.

[Cossid]

Usually (but not always), that means the device you are trying to flash is too far away from the device sending the firmware and is suffering from a poor signal. There are indeed some devices that just take multiple tries no matter how physically close they are though. As others said, you should be able to retry until successful, but keep the devices as close to each other if possible.