TreatLife SL10 Firmware v1.0.2 - SSL Error, unable to flash
See original GitHub issueHello, I purchased a new 4 pack of SL10 bulbs from Amazon, and upon trying to run the tuya-cloudcutter exploit on them, I get the following error:
Using PSK v1 - Received PSK ID version 02
SSL Error on 12 ('10.42.42.11', 59776): [SSL: DECRYPTION_FAILED_OR_BAD_RECORD_MAC] decryption failed or bad record mac (_ssl.c:1129)
Upon looking through different issues, it seems that the profile is incompatible with whatever firmware version is on these bulbs. I believe this is the same issue as referenced in #88 which seems to have people being able to flash them successfully. The fact that it isn’t allowing me to makes me think this may be a newer firmware than was referenced in that issue. I paired the bulb to Smart Life, and it seems the Main/MCU versions are both 1.0.2.
I don’t currently have the ability to dump the firmware on one, but I do have a 3D printer and I could make the jig needed to do so if required, though I am a bit hesitant to do so since I haven’t been able to successfully connect to similar chips through serial by soldering without bricking it.
What I’ve tried:
- SL10-V2 profile (with/without specified Device ID/Localkey)
- SL10-OMNI-TP120 profile (with/without specified Device ID/Localkey)
- SL20 profile (with/without specified Device ID/Localkey)
- Tuya-Generic lightbulb profiles (with/without specified Device ID/Localkey)
Here is a log file of my last unsuccessful run: log.log
Issue Analytics
- State:
- Created 10 months ago
- Comments:21 (10 by maintainers)
Top GitHub Comments
That worked perfectly, thank you!
An update has been pushed that should include a profile for this device. Please update your repo and give it a try. Please see the instructions page ( https://github.com/tuya-cloudcutter/tuya-cloudcutter/blob/main/INSTRUCTIONS.md ) for any command or input changes.
If the new profile does not work, please re-open this ticket with details (including logs) of the failure. Any feedback is appreciated.