[Device Support Request] Aqara E1 door/window sensor MCCGQ14LM

Is your feature request related to a problem? Please describe. I’m using Home assistant version 2021.10.6 with conbee 2 and i’m managed to pair the sensor with success. The problem is that the sensor is not working properly.

Describe the solution you’d like Device is not supported

Device signature - this can be acquired by removing the device from ZHA and pairing it again from the add devices screen. Be sure to add the entire content of the log panel after pairing the device to a code block below this line.

{
  "node_descriptor": "NodeDescriptor(logical_type=<LogicalType.EndDevice: 2>, complex_descriptor_available=0, user_descriptor_available=0, reserved=0, aps_flags=0, frequency_band=<FrequencyBand.Freq2400MHz: 8>, mac_capability_flags=<MACCapabilityFlags.AllocateAddress: 128>, manufacturer_code=4447, maximum_buffer_size=66, maximum_incoming_transfer_size=66, server_mask=10752, maximum_outgoing_transfer_size=66, descriptor_capability_field=<DescriptorCapability.NONE: 0>, *allocate_address=True, *is_alternate_pan_coordinator=False, *is_coordinator=False, *is_end_device=True, *is_full_function_device=False, *is_mains_powered=False, *is_receiver_on_when_idle=False, *is_router=False, *is_security_capable=False)",
  "endpoints": {
    "1": {
      "profile_id": 260,
      "device_type": "0x0402",
      "in_clusters": [
        "0x0000",
        "0x0001",
        "0x0003",
        "0x0500",
        "0xfcc0"
      ],
      "out_clusters": [
        "0x0003",
        "0x0019"
      ]
    }
  },
  "manufacturer": "LUMI",
  "model": "lumi.magnet.acn001",
  "class": "zigpy.device.Device"
}

Additional context

[KennyStier]

Will hopefully be resolved by #1151 once merged

[dmulcahey]

We have them working… unfortunately these devices need the network to reply to a command when joining with a specific manufacturer code. For EZSP coordinators there will be a new bellows release to support them. For TI coordinators you will need a new firmware.