Some Qubino 2-relay ZMNHBD devices (depending on firmware version) do not send instant status reports
See original GitHub issueChecklist:
- I am not using HomeAssistant. Or: a developer has told me to come here.
- I am not using ZWaveJS2MQTT. Or: a developer has told me to come here.
- I have checked the troubleshooting section and my problem is not described there.
- I have read the changelog and my problem was not mentioned there.
Describe the bug
Some Qubino 2-relay ZMNHBD devices that do not send “instant status” reports to zwavejs2mqtt when they are operated manually. They are all firmare version 1.1. However other ones, versioned 1.2 and 5.0 work perfectly. All these devices worked ok in the ancient zwave 1.4.
Forcing “Refresh values” to affected nodes results in correct value updates.
Device information
Which device(s) is/are affected (make/model)? QUBINO ZMNHBD Flush 2 relay (firmware 1.1) What are the node IDs? 21, 22, 28, 36, 37, 38, 50, 56
Did you change anything?
- Yes: (please describe)
- No
Did this use to work before?
- Don’t know, this is a new device
- No, it never worked anywhere
- Yes, in: (Zwave 1.4)
How are you using node-zwave-js
-
zwavejs2mqtt
(latest) docker image 2.1.1 -
zwavejs2mqtt
(dev) docker image -
zwavejs2mqtt
Manual Docker buildnode-zwave-js
branch:zwavejs2mqtt
branch:
- ioBroker.zwave2 adapter
-
HomeAssistant
version XYZ - Pkg
- Manual Docker build
node-zwave-js
branch:zwavejs2mqtt
branch:
- Manually built (as described in the docs)
- Other:
To Reproduce
Steps to reproduce the behavior:
- Go to ‘…’
- Click on ‘…’
- Scroll down to ‘…’
- See error
NA
Additional context
Nodes with issue: 21, 22, 28, 36, 37, 38, 50, 56 (Firmware 1.1) Nodes with no issue: 39 (Firmware 1.2)
Logs include manual switching on, then off for nodes 37 and 39, both endpoints (may be more than once).
Logfile:
Part of zwave2mqtt.log file for node 37. Switched on then off, both endpoints Part of zwave2mqtt.log file for node 39. Switched on then off, both endpoints
Issue Analytics
- State:
- Created 3 years ago
- Comments:65 (28 by maintainers)
Top GitHub Comments
Note that you need to exclude and re-include Qubino devices after changing the endpoint configuration.
Hi! I’ve got similar issues with old Qubino Flush 1 Relays ZMNHAA (Z-Wave chip firmware versions 1.12, Z-Wave protocol version 3.28). I’m not receiving any unsolicited updates e.g. energy reports or status updates when manually operating a switch.
Currently running zwavejs2mqtt version 5.10.1 (Z-wave JS 8.6.1).
I migrated from Fibaro Home Center 2 (where all Qubino devices worked just fine) to running Home Assistant on a NUC with an AEON Labs Gen5 USB Z‐Stick Controller.
How should I proceed, should I open a separate issue? But I’m not sure which logs you want and how to get them…