Network Died and Can't Recreate

Is your problem within Home Assistant (Core or Z-Wave JS Integration)?

NO, my problem is NOT within Home Assistant or the ZWave JS integration

Is your problem within ZWaveJS2MQTT?

NO, my problem is NOT within ZWaveJS2MQTT

Checklist

• I have checked the troubleshooting section and my problem is not described there.

• I have read the changelog and my problem was not mentioned there.

Describe the bug

Woke up a few days ago and none of my z-wave devices were responding. Thought it was a bad stick so I ordered a replacement and am getting the same results.

My setup is a rasberry pi 4 with zwavejs2mqtt running in a docker container and then HomeAssistant points to that. At this point I have tried 3 different zooz zst10 700 sticks as well as an aeotec z-stick 7 plus. I have upgraded the firmware on all of the sticks to 7.17.2. I have factory reset the sticks, blown away the docker container and recreated it, switched to try and use the zwavejs addon in HA, and switched to try the zwavejs2mqtt addon in HA.

During all of this I thought I had an nvm backup of the original stick, but apparently not. However, I have factory reset a few different zwave devices in my house (a switch, a sensor, a plug, and the garage door controller) to try to begin recreating the network.

No matter which configuration I try, the sticks don’t see anything in both inclusion and exclusion mode. I’ve turned logging up to silly and all I see are the API calls to start and end the inclusion or exclusion modes.

Device information

Have tried both the Aeotec z-stick 7 plus as well as a few zooz zst10 700’s. Firmware on all of them was upgraded to 7.17.2.

How are you using node-zwave-js?

• zwavejs2mqtt Docker image (latest)
• zwavejs2mqtt Docker image (dev)
• zwavejs2mqtt Docker manually built (please specify branches)
• ioBroker.zwave2 adapter (please specify version)
• HomeAssistant zwave_js integration (please specify version)
• pkg
• node-red-contrib-zwave-js (please specify version, double click node to find out)
• Manually built from GitHub (please specify branch)
• Other (please describe)

Which branches or versions?

version: node-zwave-js branch: 10.0.4 zwavejs2mqtt branch: latest (7.1.0) HA zwave_js integration: 0.1.70

Don’t run both zwavejs2mqtt and the HA zwavejs integration at the same time, but during the troubleshooting process I was trying everything.

Did you change anything?

no

If yes, what did you change?

No response

Did this work before?

Yes (please describe)

If yes, where did it work?

House had a successful zwave mesh with over 20 mixed devices (locks, switches, outlets, etc) zwavejs2mqtt-store 2.zip

Attach Driver Logfile

zwavejs_2022-09-09.log zwavejs_2022-09-08.log

[wraith1385]

My network has now been stable for over a week. No idea what changed.

[AlCalzone]

According to the log, +9.9dBm TX power, region USA. So there should be at least some signal.